logo
banner

Blog Details

Created with Pixso. Home Created with Pixso. Blog Created with Pixso.

Auto Cleaning Solar Lights On A LoRa Network: What To Plan Before You Buy

Auto Cleaning Solar Lights On A LoRa Network: What To Plan Before You Buy

2026-11-20

Two things separate a solar lighting project that runs for ten years from one that gets switched off in year two: whether the panels stay clean, and whether anyone can see a fault before a resident calls. The LRQX series addresses both, but the planning is on you. Here is the checklist we walk through with buyers.

Step 1: decide the control layer

Each lamp has a LoRa module. The gateway (JWL-SWC) collects them, and the gateway reaches your office over 4G, 3G or GPRS. So the question is not "can it be monitored" but "where does the gateway go". Put it within LoRa range of every lamp in the cluster, high enough to clear buildings, and give it mains power plus a small UPS. One gateway comfortably handles a street cluster; a long road may need two or three.

Auto Cleaning Solar Lights On A LoRa Network: What To Plan Before You Buy

Step 2: set the cleaning rhythm

The roller brush runs on a schedule. In dry dusty regions we start at once every two days; in mixed climates once a week. The brush sweeps dust into a channel, rides on an inner rail, and is detachable. Order one spare brush per 15-20 lamps and you will never be stuck waiting on a part. Cleaning restores roughly 15-20% of charging speed on a soiled panel, which is the cheapest capacity you will ever buy.

Step 3: pick the size honestly

60W / 8400Lm for paths and courtyards, 80W / 11200Lm for access roads, 100W / 16000Lm for main internal roads. All three run 210Lm/W, 2700-6500K, 150x75 degree beam, LiFePO4 (12.8V 30/36/48Ah), aluminum case, optional hard-pressed pole.

Auto Cleaning Solar Lights On A LoRa Network: What To Plan Before You Buy

Six questions to ask before signing

1. What happens if the gateway goes down?

Each lamp keeps its own PIR and time settings. You lose visibility, not lighting. That is the correct failure mode; ask your supplier to confirm it.


2. How do I know the cleaning actually runs?

The controller logs each sweep and reports it. If the dashboard shows no sweeps for a week, the brush motor or rail needs a look.


3. Can I change the schedule remotely?

Yes, through the gateway. Useful when a construction phase is kicking up dust next door.


4. What is the maintenance visit then?

Brush swap when worn, panel inspection once a year, battery check at year three. No lamp-head opening, no cable tests.


5. Is the brush safe on coated glass?

The roller rides on the frame rails, not on the glass surface, so there is no abrasion of the panel coating.


6. Can I phase the purchase?

Yes. Buy the lamps and one gateway first, add gateways per cluster later. The lamps do not care whether a gateway exists yet.

What our factory brings to the project

Where a light is built decides how it behaves in year three. Ours: 30,000 m², three assembly lines alongside two SMT lines that make the driver boards in house, and an aging room where every finished fixture sits at full load for 48 hours before packing.

Each batch gets an IP66 spray test, each carton a drop test, each battery a capacity check at 0.5C. Twelve inspection points travel with the goods, one per serial number. We build around 1,000 sets a month of this series, so 300 to 500 set orders slot in normally. Bulk lead time is 20-25 days.

Send us your pole layout sketch, even a hand drawing. We will come back with wattages per segment, gateway positions and a brush spare quantity, and then the quotation is actually comparable with the next one you receive.