logo
banner

Blog Details

Created with Pixso. Home Created with Pixso. Blog Created with Pixso.

LRQX 60W vs 80W vs 100W: A Plain Walk Through The Spec Sheet

LRQX 60W vs 80W vs 100W: A Plain Walk Through The Spec Sheet

2026-11-20

Spec sheets are written to be complete, not to be read. So here is the same sheet, translated into decisions.

The one number that matters: 210Lm/W

All three models run at 210 lumens per watt, which is why a 60W light gives you 8400 lumens instead of the 6000 you would get from an older 100Lm/W design. Practically: a 60W LRQX can replace a 100W fixture on the same pole. If your current supplier quotes 100W and 6000 lumens, you are paying for watts you cannot see.

Size by size

60W / 8400Lm / 18V 60W panel / 12.8V 30Ah. The compact one at 1233mm and 20.6kg. Good for park paths, residential lanes and courtyard lighting on 4-6m poles. One person can lift it, which sounds trivial until you are on a scaffold.

80W / 11200Lm / 18V 70W panel / 12.8V 36Ah. The middle child, 1543mm, 22.8kg. This is the one most municipal access roads end up with: 6-8m poles, mixed pedestrian and vehicle use, and enough headroom for two cloudy days without dropping to a dim profile.

100W / 16000Lm / 18V 100W panel / 12.8V 48Ah. 1863mm, the long one. For main internal roads and parking aisles with 8-10m poles and 35-45m spacing. Note the panel jumps to 100W here, not 70W, because the battery is bigger and needs the extra harvest.

 A No-Nonsense Guide To Choosing A Solar Parking Lot Light

What is shared across all three

Auto cleaning roller brush on an inner rail, detachable for replacement. LoRa control module (gateway JWL-SWC talks to 4G/3G/GPRS, gateway to lamp over LoRa). 2700-6500K, 150x75 degree beam, PIR or time control, aluminum case, hard-pressed pole option. So the platform is identical; only the muscle changes.

Six questions we get weekly

1. 100W or 80W for a 6m pole? 80W. A 100W on a 6m pole gives you glare and a hotspot at the base. Match wattage to mounting height, not to the neighbour's order.

2. Can I mix sizes in one project? Yes, and most projects should. Main road in 100W, side paths in 60W, one gateway covering both. It reads as one lighting scheme rather than three purchases.

3. What is the real difference in light? Flux, not wattage: 8400 vs 11200 vs 16000 lumens, all at the same 150x75 degree spread. The 100W covers roughly 1.7x the area of the 60W at the same lux level.

4. Why 12.8V instead of 25.6V? Because this series uses 4-cell LiFePO4 packs under 50Ah. Lower voltage means fewer cells in series and a simpler BMS, which is more reliable in the field for this size class.

5. Does the cleaning brush use much power? The brush motor draws a small fraction of one day's harvest for a few minutes of travel. It is scheduled when the panel is not at peak output anyway.

6. Can the light be retrofitted on existing poles? Yes, if the pole diameter matches our bracket range. Send a photo of the pole top and we will confirm before you order.

 A No-Nonsense Guide To Choosing A Solar Parking Lot Light

Factory, briefly

Thirty thousand square meters, three assembly lines, two SMT lines making our own controller boards. The useful part is what happens before shipping: 48 hours on full load in the aging room, an IP66 spray test on every batch, a drop test on the packed carton, and a battery capacity check at 0.5C instead of a label reading. Twelve checkpoints are recorded per unit on a traveler card, so a serial number pulls its own build record. Capacity is about 1,000 sets a month, OEM branding from 50 sets, samples in 7 days, bulk orders ship in 20-25 days.

Send us the pole height and road width, and we will tell you which of the three is the honest answer, even when it is the cheapest one.