Most of the messages we get start the same way: "Hi, I need solar lights for a parking lot, how much?"
Fair question, but the honest answer is that the price you get depends on seven things, and six of them have nothing to do with us. Here is how we usually walk a buyer through it, using our LP1 series as the example.
![]()
Forget the label on the box for a second. What matters is how much light lands on the ground, and where. A 40W LP1 puts out about 6400 lumens at 210Lm/W. That is plenty for a villa car park or a small lot with 6-8m poles. For a 30-space commercial lot with 10-12m poles and 40-45m spacing, the 80W version at 12800 lumens is the safer call. If someone quotes you 200W for a small lot, ask them for a lighting layout, not a bigger number.
Three to five, depending on the mode you pick. The battery packs run from 922Wh up to 1536Wh across the 40W to 80W models, and we set the discharge profile based on your local sunshine hours. If a supplier promises "7 days of backup at full power" on a fixture this size, do the math on the pack first.
This is a real complaint we hear about cheap units. On the LP1 the sensor runs a dim-standby / full-boost profile: for example 4 hours at 100%, then 30% standby with a jump to 100% when someone walks through, or 6 hours at 60% with 20% standby. You set the profile at installation, and the light stops waking up for stray cats after the first week of tuning.
It means you can hose the housing down and monsoon rain does not get in. On a parking lot light that matters more than on a garden fixture, because the housing sits low on the pole, right where spray from cars and irrigation hits it.
![]()
Yes, and this is the feature most buyers do not know to ask for. The LED modules tilt from 15 to 45 degrees, and a second module bolts to the underside of the same head. One pole, one battery, light on both sides. That single detail often removes half the poles from a project.
The pack is a separate assembly inside the housing. It is not potted into the head, so it can be swapped on site with a screwdriver instead of replacing the whole fixture. Ask any supplier whether their battery is serviceable before you sign.
Ask for three things: the aging room, the IP test, and a traveler card from a previous order. Ours runs three assembly lines in a 30,000 m² plant, with two SMT lines for the driver boards. Every fixture spends 48 hours under full load before packing, every batch gets an IP66 spray test, and the inspection records travel with the carton. Monthly output for this series is around 1,200 sets, so a 300-set order is a normal production run, not a special favour.
If you want, send us your lot layout and pole height. We will come back with a wattage, a spacing suggestion and a lantern layout, and then the price actually means something.